Author Topic: PLC Issues  (Read 18266 times)

Santaji

  • Guest
PLC Issues
« on: February 11, 2006, 09:48:03 PM »
Hello,
I m a student of engineering college in india and very much interesting in PLC programming for "Allen Bradley-Modicon 64 Bit".
Is there any online tutorial testing software for the same?

Will there any effect to the PLC if the power supply for Input Card and Output Relay Card is through the same point and not seperate?
I am getting some here. If i give any single input then the PLC shows the same but if i connect the data pin to Output Relay Card then only the PS MCB gets tripped and the Fuse in O/P Card damaged everytime. I chacked the connector of the cable but its ok. Any suggessions??
 ???

Regards,
- Santaji

evanh

  • Jr. Member
  • Posts: 59
  • y=A+B*(1-cos(2*Pi*x))
    • View Profile
Re:PLC Issues
« Reply #1 on: February 12, 2006, 09:19:16 PM »
I don't get this.  Why do so many people post questions on this forum about AB PLCs with no apparent association to TriPLCs?


Evan

support

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3174
    • View Profile
    • Internet Programmable PLCs
Re:PLC Issues
« Reply #2 on: February 13, 2006, 08:32:45 AM »
Some people just don't seems to bother to spend a few seconds to read the purpose of the forum is meant for  supporting the TRi's range of PLCs.  That's why they have to be removed or relocated by the moderator.
Email: support@triplc.com
Tel: 1-877-TRI-PLCS

brettski

  • Newbie
  • Posts: 11
    • View Profile
    • PCE Technical
Re:PLC Issues
« Reply #3 on: March 21, 2006, 02:11:27 PM »
POWER TO THE PEOPLE!!!

POWER TO THE TRI-PLC PEOPLE!!!


Come on guys!  This is help for the TL people.

I agree with the comments!