Internet PLC Forum
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
News:
Home
Help
Search
Login
Register
Internet PLC Forum
»
General
»
Technical support
»
H11l2
« previous
next »
Print
Pages: [
1
]
Author
Topic: H11l2 (Read 11861 times)
artkraft
Newbie
Posts: 22
I'm a llama!
H11l2
«
on:
June 27, 2015, 08:30:04 PM »
Wired H11L2 as per diagram in manual (24v to 5v). When I test it by grounding pin #2 to simulate sink from PLC I only read .1 vdc (multimeter) to the stepper driver. shouldn't I read 5v Pin #4 to grnd.
Logged
support
Global Moderator
Hero Member
Posts: 3174
Re:H11l2
«
Reply #1 on:
June 30, 2015, 07:31:18 PM »
If you check the datasheet of H11L2:
https://www.fairchildsemi.com/datasheets/H1/H11L1M.pdf
It is mentioned that the logic output is open-collector and is an inverter design. I.e. when the input LED is turned ON the output is pulled to low. If the input LED is OFF the output needs a pull up resistor to pull up to +5V.
Logged
Email: support@triplc.com
Tel: 1-877-TRI-PLCS
Print
Pages: [
1
]
« previous
next »
Internet PLC Forum
»
General
»
Technical support
»
H11l2