Author Topic: Nano Relays  (Read 12203 times)

BC SYSTEMS

  • Full Member
  • Posts: 146
    • View Profile
Nano Relays
« on: April 15, 2011, 02:28:33 AM »
Hi Guys,

I'm using the outputs on a nano to indicate if the communication on the serial and Ethernet port is working OK.  I need all four outputs which is fine for  outputs 1 & 2 but 3 & 4 are also connected to relays.

When the comm's is running the relays are on and off every second which is probably not doing them any good but perhaps more important, they are driving me mad!

Would there be any adverse situations if I just de-solder the relays.

Cheers

« Last Edit: April 15, 2011, 03:31:50 AM by BC SYSTEMS »

support

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3174
    • View Profile
    • Internet Programmable PLCs
Re:Nano Relays
« Reply #1 on: April 15, 2011, 10:29:04 AM »
You can de-solder the 2-relays and they will be taken out of service. But you will need to short the solder pads on the solder side of the Nano-10 to re-route the MOSFET driver to the screw terminal block.
Email: support@triplc.com
Tel: 1-877-TRI-PLCS

BC SYSTEMS

  • Full Member
  • Posts: 146
    • View Profile
Re:Nano Relays
« Reply #2 on: April 15, 2011, 11:32:12 AM »
Ok thanks.  

Cheers