« previous next »
Pages: [1]

Author Topic: Input stays on  (Read 6101 times)

k1w1

  • Newbie
  • Posts: 19
  • I'm not a llama!
    • View Profile
Input stays on
« on: March 08, 2007, 11:59:36 PM »
Hi have a problem with a T100MD1616, for some reason input 7 seems to have latched on and stays on even with the connector block removed.  Any ideas ?
Logged

FQ-ONG

  • Jr. Member
  • Posts: 61
    • View Profile
Re:Input stays on
« Reply #1 on: March 09, 2007, 02:48:55 AM »
One of possible reason is IC for related input was corrupted.
Logged

k1w1

  • Newbie
  • Posts: 19
  • I'm not a llama!
    • View Profile
Re:Input stays on
« Reply #2 on: March 09, 2007, 01:02:19 PM »
Ok  so whats the best way to fix it ?  I tried reloading software but on line monitoring shows input still on. Everything else works fine.
Logged

support

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3171
    • View Profile
    • Internet Programmable PLCs
Re:Input stays on
« Reply #3 on: March 09, 2007, 03:14:22 PM »
It is a bit usual for the input to be stucked ON. Input #7 goes straight to the CPU pin #62. If there is any damage to the pin then the CPU need to be replaced.

Alternatively, you can simply not use this input and move the label name to another input. You don't need to change the program at all.
Logged
Email: support@triplc.com
Tel: 1-877-TRI-PLCS
Pages: [1]
« previous next »