Interrupt to monitor physical micro-switch on and off

[bobsamuel]

Hi,

Hardware being used: FMD88-10 and T40H-Relay

I have an application in which the NO and NC states of a physical micro-switch must be monitored in real-time to change the state of a Relay and/or Output.  The switch's state must be monitored and responded to without waiting for the next ladder scan.

I understand how to use an interrupt (INTRDEF) and related Custom Function to monitor the micro-switch and set a Relay and/or Output, from off to on.  

Question: How can an interrupt (INTRDEF) and related Custom Function be used to monitor the same micro-switch to re-set a Relay and/or Output, e.g. from on to off?

Suggestions will be appreciated.  Thanks, Bob

[BetterBath]

To monitor the micro-switch for changes from on to off using an interrupt (INTRDEF) and Custom Function, set up a second interrupt routine for this specific condition. This way, you can respond to both state changes of the micro-switch in real-time.
Junkremovalbulktrashpickuprubbishhaulingclickherevisitour sitejunkdisposalhaulingtrashpickup
Click herehaulinglawn carerepairtallahasseeour sitejunk removalclick herehandymanjunk haulingjunk removersclean outcape coralwebsitehandymansour serviceslandscapingfloridajunk removallandscaping.