« previous next »
Pages: [1]

Author Topic: LCD Current Limiting Resistor  (Read 12559 times)

rosssyscon

  • Newbie
  • Posts: 6
  • Thanks for the help!
    • View Profile
LCD Current Limiting Resistor
« on: September 10, 2003, 04:45:06 AM »
We are using a 4x20 LCD display. I noticed that the 150 Ohm resistor is getting REAL :o HOT. It will burn your finger to the touch. The resistor lead is screwed under terminal 15 and the other soldered to the power wire.

Should the resitor be attached to a metal surface with some heat sink compund? ???

Thanks again,
« Last Edit: December 31, 1969, 04:00:00 PM by 1076562000 »
Logged

support

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3174
    • View Profile
    • Internet Programmable PLCs
Re: LCD Current Limiting Resistor
« Reply #1 on: September 10, 2003, 11:06:37 AM »
The 150 ohm resistor is 5W in ratings. It is meant to be HOT! Anyway, if you can connect it in contact with some metal surface to help carry away the heat it is always appreciated! Otherwise, just good air flow will be sufficient.
« Last Edit: December 31, 1969, 04:00:00 PM by 1076562000 »
Logged
Email: support@triplc.com
Tel: 1-877-TRI-PLCS

rosssyscon

  • Newbie
  • Posts: 6
  • Thanks for the help!
    • View Profile
Re: LCD Current Limiting Resistor
« Reply #2 on: September 10, 2003, 11:47:12 AM »
;D Thanks for confirming.
« Last Edit: December 31, 1969, 04:00:00 PM by 1076562000 »
Logged
Pages: [1]
« previous next »