Disabling PWM Output

[bmillereng]

Is there a way to disable the PWM output after it is activated, without a reboot, so the same output can be used normally from ladder logic or Basic? I have not been able to find anything in the documentation.

[support]

Once defined as a PWM there is no way to re-define it as a normal output until a reboot occur. The only way to use it like a regular output is use TBASIC to set it to 100% duty cycle for fully ON and 0% duty cycle for fully OFF.

[bmillereng]

That is what I suspected. Your suggestion might work fine. Thanks!