Omoron CP1E N30

[Tito]

Hi,
I am trying to establish communication between PLC WebServer (serial port setup) and Omron.

I did set up as follows:-
Comm: com1
Databits: 7
Parity: Even
Baud rate : 9600
Stop Bits: 2
Timeout:500

In command string  : @00MS       'STATUS READ
follow by pressing "FCS"
gives FCS = 5E
than type in command string : @00MS5E*
follow by return key
message prompt : Warning no response form PLC.
i did use the same cable which used in FMD. Please do advice

[Tito]

  Hi
I did manage to sort out that after re-configure the serial cable according to omron connection using RS232 ports.