Author Topic: Wiring assembly for A/I  (Read 11557 times)

Tim Chavis

  • Guest
Wiring assembly for A/I
« on: July 16, 2003, 03:18:47 PM »
Is there soom kind of prebuilt wiring assembly for the A/I's on your md888+? It seems like as many resources as you have, you could provide some means to terminate your wirring to the A/I. The 15 pin D-sub just takes to long to solder up. Im not griping just wondering! thanks , Tim
« Last Edit: December 31, 1969, 04:00:00 PM by 1076562000 »

support

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3174
    • View Profile
    • Internet Programmable PLCs
Re: Wiring assembly for A/I
« Reply #1 on: July 17, 2003, 08:34:58 AM »
You can purchase a D-sub connector with a crimp end which allows you to quickly crimp 15 conductor ribbon cable to it and you can then split the ribbon cable to get to the signals. Check www.digikey.com and search for D-sub crimp connector.

If there are enough demand (say 100 pieces at least) we can make a board with screw terminals and connect to the T100MD888+ PLC's analog port via ribbon cabled D-sub connectors.

T100MD1616+ and T100MD2424+ both have screw terminals for their ADCs.
« Last Edit: December 31, 1969, 04:00:07 PM by -1 »
Email: support@triplc.com
Tel: 1-877-TRI-PLCS

Tim Chavis

  • Guest
Re: Wiring assembly for A/I
« Reply #2 on: July 17, 2003, 01:59:07 PM »
Thank's alot that should work fine, But it wouldnt take long to sell any of the bourds you just talked about.        Thanks again ,     Tim
« Last Edit: December 31, 1969, 04:00:00 PM by 1076562000 »