Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - edmund

Pages: [1]
1
Technical support / stepper motor encoder pulse measurement
« on: January 15, 2003, 04:41:04 PM »
Can i use the HSC for stepper motor pulse measurement? or can i use PMON to measure 2?

Can u tell me what is the general guidlines for entering values for the PIDDEF?

2
Technical support / how to turn off the stepcount command?
« on: January 15, 2003, 08:36:51 PM »
i am using the stepcount command to read the step count. but i just need to take the counts for a duration of 1 minutes, how to take the stepcount readings & turn off the stepcount so that i just got the data collected over 1 minutes only?

3
Technical support / Commands to use for reading stepper motor encoder?
« on: January 12, 2003, 10:52:55 PM »
I am new to Trilogic product.  I am trying to program the PLC to receive the feedback pulse signal from the stepper motor. I read the Trilogic help file & i think it is the command "STEPCOUNT", but the PLC software does not recongnize the "STEPCOUNT" command (I had entered the command as such "STEPCOUNT 1".

Please kindly show me the proper command to receive pulse signal from stepper motor encoder?

Pages: [1]