1
General Discussions / steper motors like a dc motors
« on: April 02, 2022, 11:02:41 AM »
Is there any way to make a stepper motor work like a dc motor, that is, with a relay on to run continuously until the relay turns off?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Technical support / Re: I do not get interruptions with FMD88
« on: June 02, 2021, 07:46:49 AM »
Thanks Gary, surely these examples will be very useful as a guide to start generating good stepper motor controls through this PLC
3
Technical support / Re: I do not get interruptions with FMD88
« on: May 30, 2021, 03:13:14 PM »
Thank you very much for the information, I have already been able to test with a real board and I have seen that everything works fine. Where I could see examples of the use of interruptions to learn from those who have already done this experience?
4
Technical support / Re: I do not get interruptions with FMD88
« on: May 29, 2021, 04:06:41 PM »
Thank you very much for your prompt response. So I defined them, but I have doubts if the interruptions can be simulated with the simulator I dont have yet a real board to test it
5
Technical support / I do not get interruptions with FMD88
« on: May 28, 2021, 05:23:43 PM »
I haven't done anything with PLC for a long time. A client asks me for a simple application to control two stepper motors with their corresponding limit switches for the detection of the Home and a switch to detect a position that varies and from which I must memorize the two coordinates. I want to detect this last switch by interruption but I have not been able to do it, not even the interrupt example that comes with the trilogi TL67 software works for me. Is there a place where I can see examples of applications with interruptions or a tutorial?
Any help is welcome
Any help is welcome
Pages: [1]