Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - researchdog

Pages: [1]
1
Technical support / Communication with an E10+Relay
« on: September 17, 2007, 05:07:54 PM »
I am using an E10+relay as remote I/O for a TMD888. Using TL Server on my laptop with your Auto 485 convertor connected to the E10 relay I can turn on output#1 using WB08FF and can turn it off using WB08FF. When I try to do the same with the TMD 888 using the NETCMD$ I get no results. Before sending the NETCMD$ i set the baud rate of Comm 3 using "Setbaud 3,3"  Any suggestions will be appreciated.

Pages: [1]