Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cws

Pages: [1]
1
Technical support / Re:Change counter set value
« on: October 05, 2005, 08:11:42 AM »
Thank You,

The wildcard FCS works fine.  I am using Trilogy 5.1 with TLServer 2.0.  Is there any way I can get the latest version?

2
Technical support / Re:Change counter set value
« on: October 04, 2005, 09:39:45 AM »
Replying to my own question.

I was able to change the counter set value by calculating the FSC value for the command.  It takes a while doing it by hand, but it does work.  Is there any simpler method?

3
Technical support / Change counter set value
« on: October 04, 2005, 08:57:13 AM »
Can I use the serial port setup window to send a command to the PLC to change a counter set value.

 I tried to use the command "Wu010005*".  The PLC responds with "Warning: No response from PLC".

Then I tried:  "@Wu010005*".  The PLC responded with "@01FE42*".  I guess that means I must have a correct FSC code in my command, but this is difficult if I just want to send a command using the server.

Is there any way to simply change a counter value without reprogramming?

4
Technical support / Re:interval timer
« on: September 14, 2005, 06:05:18 AM »
Thanks, I'll give it a try.

5
Technical support / interval timer
« on: September 13, 2005, 06:38:02 AM »
Is it possible to create a stopwatch with any of the T100 PLCs?

Pages: [1]