Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Gcovington

Pages: [1]
1
Technical support / Re:HMI to FMD communication protocol
« on: October 29, 2015, 07:29:25 AM »
I downloaded the latest from Weintek V5.02.02.001 Build 2015.10.06.  When I go to add new device there is not a Tri PLC available.  I found some drivers from the TriPLC website Tri_FX.dll and Tri_FX.e30 but I think these are for the F-series plcs.   I put them in the folders as recommended but they do not show up in the list of devices either.

Maybe I should uninstall and try again?

2
Technical support / HMI to FMD communication protocol
« on: October 28, 2015, 03:18:14 PM »
I recently purchased an FMD88-10 plc and KEP HMI mT6070ie.  I also purchased the cable to connect them.  I am having trouble establishing communication between the PLC and the HMI.  I am using Com1 on the PLC which I set the baud and protocol in the first scan.  I have downloaded sample projects in the HMI but have not found a matching sample for the FMD plc that I could use as a starting point to establish communication and figure out the addressing.

If anyone has a sample project with the KEP HMI and FMD processor that could get me started it would be much appreciated.

I have tried the Free Protocol and the Modbus Server.  

Thanks,

Glenn

Pages: [1]