Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - MikeKitch68

Pages: [1]
1
Technical support / Re:SETSYSTEM 252
« on: May 20, 2015, 06:45:19 PM »
We need to back up almost all of the DM registers.  We are doing some data collection with the unit.  We will look at getting the RTC unit.  Thanks for all your help on this.

2
Technical support / Re:SETSYSTEM 252
« on: May 20, 2015, 12:48:42 PM »
I am doing the Save_EEP and Load_EEP functions but thought with the way it was stated, I could use the single step by itself.

We are trying to save the DM registers on Power Failure, we are doing a ForNext to save all DM (SAVE_EEP) when a power failure is detected.

Would that be the best way?

Thanks

3
Technical support / SETSYSTEM 252
« on: May 20, 2015, 05:09:41 AM »
I am not able to get the SETSYSTEM 252, 0 working properly.  It does not back up the data variables.  In the documentation, it states the following:

Nano-10 allows you to do so easily using a single SETSYSTEM command, as follow:
SETSYSTEM 252, 0
Upon execution of the above command, the Nano-10 CPU will erase a special flash memory area used to
backup the pseudo EEPROM and it will then copy the entire pseudo EEPROM memory data to the flash
memory

Pages: [1]