1
Technical support / Re:Time/Date
« on: August 20, 2014, 03:01:00 PM »
Is there a easy way to switch between 12-hour time vs 24-hour time. Or does a custom function need to be written?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
3
Technical support / Time/Date
« on: August 13, 2014, 12:26:10 PM »
Are you able to change the time and date of a SmartTile through an HMI via modbus?
4
Technical support / Re:Hour meter
« on: August 12, 2014, 01:39:10 PM »
I have constructed an hour meter like the one pictured above, is it possible to place the "hour" portion into a float variable so i have no limit on run hours, and also it can be displayed as x.x on my hmi?
5
Technical support / Re:FMD88-10 RS-485
« on: June 05, 2014, 03:15:32 PM »
I was able to figure it out, if anyone needs help communicate between these two devices let me know.
6
Technical support / FMD88-10 RS-485
« on: June 05, 2014, 09:10:28 AM »
Has anyone hooked up RS-485 (2-wire) to communicate between the FMD and an Idec HMI (HG2G) series? I am having issue getting them to communicate. Seems like everything is already setup on the FMD just need assistance on the HMI side.
7
Technical support / Re:Hour meter
« on: June 04, 2014, 07:21:14 AM »
Thanks Gary, I was able to figure it out, using the non-volatile memory.
8
Technical support / Re:Hour meter
« on: June 03, 2014, 03:04:47 PM »
I also used this hour meter and its working great. How would you store the values so that when you power down the PLC the hour meter will be at the same point where it was before?
9
Technical support / Timers Showing -1
« on: June 03, 2014, 02:54:20 PM »
When my timer is inactive, or completed it shows a -1 on my HMI. Is there a way to replace this with a 0?
10
Technical support / Pausing PID
« on: June 03, 2014, 02:51:57 PM »
Hello All,
I'm running a PID loop on a FMD8810, it works great. I am using a flow meter to control an automated valve which varies flow until my setpoint is achieved. Under certain conditions in order to achieve the setpoint the valve allows the line to be over pressurized. I am already reading this line presssure through a transducer. Is there a simple way to pause the PID loop at pressure X and then resume after once the pressure drops below x?
I'm running a PID loop on a FMD8810, it works great. I am using a flow meter to control an automated valve which varies flow until my setpoint is achieved. Under certain conditions in order to achieve the setpoint the valve allows the line to be over pressurized. I am already reading this line presssure through a transducer. Is there a simple way to pause the PID loop at pressure X and then resume after once the pressure drops below x?
Pages: [1]