Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ricv7

Pages: [1]
1
Technical support / T100MD2424+ PLC Power Interrupt
« on: January 03, 2013, 04:30:45 AM »
Hello again. I got another issue to solve. How do i get my program run automatically when power is interrupted? ive tested my program thru the simulation and it runs well. It runs on a scheduled time. During power interruption, it just dont run anymore. any reference i can go thru to solve this? appreciate ur help once again.

2
Technical support / Re:T100MD2424+ I/O's not working
« on: January 03, 2013, 04:17:08 AM »
thanks for the advise.  I got it working.  :)

3
Technical support / Re:T100MD2424+ I/O's not working
« on: January 02, 2013, 06:17:11 AM »
pics

4
Technical support / Re:T100MD2424+ I/O's not working
« on: January 02, 2013, 06:14:07 AM »
btw, here's the picture of my T100MD2424 PLC im referring to. only output 5 &6 seems to be working. the rest of the IO's are all off.

5
Technical support / Re:T100MD2424+ I/O's not working
« on: January 02, 2013, 05:27:30 AM »
24V is already connected to the mcr input. otherwise program may not be successfully transffered to the PLC, am i right? i have also followed the installation properly. pls enlighten me further.

6
Technical support / T100MD2424+ I/O's not working
« on: January 01, 2013, 09:41:10 PM »
There seems to be a problem with my newly bought T100MD-2424+ PLC. After transferring my program in to PLC, only output 5 & 6 are working. The rest of the I/O's are not working. My basis is the red led near the Output and the Green LED near the Inputs. Im using a 24V power supply also bought from TRi. Is there a way or a program to test if PLC hardware is broken? Ive done a simple progrmam to test my IO's and works well in the simulation. however, in the actual PLC, its not working. Please help.

Pages: [1]