Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - TriRob84

Pages: [1]
1
Technical support / Re: web page 0.htm DM32 value display
« on: October 08, 2019, 01:56:23 AM »
Thanks for directions, I do have script for Integer and float to be displayed on build in htm pages so gonna try workout DM32 to be displayed based on that. Thanks again.

2
Technical support / web page 0.htm DM32 value display
« on: October 07, 2019, 02:14:33 AM »
Hi, on base 0.htm page there are DM1 to DM4 values displayed, what directions should I take if I want to display a value from DM32 double register  in one of display fields. My Nano-10 is collecting data from external Energy meter via Modbus where used energy counter is above 65565 so it clocked up next register by one. Im seeing 13885 and 1 in two registers, I also can see correct DM32 value in Nano just don't know how to change what type of register is displayed on HMI display (double instead of integer) and/or how to read DM32 in N.js file.Regards. 

3
Technical support / Re:NANO-10 plc - PART NUMBER NEEDED
« on: April 16, 2015, 10:50:27 AM »
No 1 is on order.

Thanks.

4
Technical support / NANO-10 plc - PART NUMBER NEEDED
« on: April 11, 2015, 10:08:02 AM »
Hi,

Need somebody to advise on part No of marked red IC (see link below)- mine blown up and I'm not able to read anything of it.
Thanks in advance.

www.robcomcorp.pl/nano10/nano10.JPG

5
Technical support / Re:Nano PLC with Advantys OTB
« on: July 26, 2012, 06:18:07 AM »
Thanks for your directions, using function:
PRINT #4 "<MBTCPCONNECT 192.168.254.200:502>" i can connect to remote I/O over ethernet.

READMODBUS(X,X,X) let me to read word status.

Mapping this word to any 16 bit INPUT is just simple way to see each remote Input status back in Nano PLC.

Thanks.


6
Technical support / Nano PLC with Advantys OTB
« on: July 25, 2012, 05:09:03 AM »
Hi there,

Wish to know what is the best way to read I/O statuses back to Nano PLC from device (Advantys OTB) over ethernet.

Using modbus poll software i can read device registers:
1(bits 0 to 11 each one for input status)
2 temperature channel 0
3 temperature channel 1
4 temperature channel 2
5 temperature channel 3

Thanks for any advice.

Pages: [1]