Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Dika12

Pages: [1]
1
Technical support / Re:?Pause? LED comes ON
« on: July 13, 2012, 08:23:05 AM »
it runs for couple of seconds and ?PAUSE? come up again. You can almost execute the whole program by few sec steps.

I didn?t use any ?PAUSE? statements in my code.

Anyway ?  I did try my WIN7 64-bit professional to run as XP and programming thought COM port still had the same behavior. I also managed to get another XP laptop to try. Somehow COM port programming didn?t work with it at all. Makes me wonder if there is something with COM on the PLC board.

Anyway. I switched to Ethernet programming and this is works every time so far.  Worked with XP, then I switched to Win7 and even removed ?RUN as XP? and still works every time.  

2
Technical support / Re:?Pause? LED comes ON
« on: July 11, 2012, 12:45:15 PM »
Is there instructions how to connect to PLC over internet within company network? Could be helpful. Thanks.

3
Technical support / Re:?Pause? LED comes ON
« on: July 11, 2012, 12:35:17 PM »
Nop, there isn?t "Checksum error" or "program corrupted". The first message I have after I get online monitoring running is ?PLC already paused by user!?. I can clear it and it stops again in a couple seconds.

I do use COM port programming ? the kit I got a month ago and using as is.

Also I?m using shortcut from ?start? menu. I just made a shortcut from it to the desktop.  And I just checked ? it does go to the TL6Launcher.exe.  

I?ll check other things you are suggesting.

4
Technical support / ?Pause? LED comes ON
« on: July 11, 2012, 10:24:24 AM »
Hi,
I may need a hint where to look for problem I have.
I?m using FMD88-10 with LCD module. Computer is WIN 7 64-bit with i-TRiLOGI Version 6.43 build 01. My Java directory has j2re1.4.2_19 and jre6 if that matter.
During last few weeks I made a good progress developing code, but as more I?m moving along (as larger may code I guess), as more and more often I see that PLC?s ?Pause? LED comes ON rather quickly after the PLC been programmed. The weird part is that it isn?t consistent. I can load the same code over and over and over again and it will run only 20-25% of the time. Resetting or rebooting isn?t helping at all. But if its runs it runs all the time (reboot or reset ? still works).
It seems to be something with how PLC is programmed, but it is never fully dead. When light is ON program is running for few secs and there is always something on the screen.

Thanks for advice

Pages: [1]