Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Foxdesign

Pages: [1]
1
Technical support / customise control web page
« on: July 24, 2012, 06:36:39 AM »
Hi,
I would like to do this as per "level 2 user" as mentioned in the manual, but i have no information as to how. Can someone possibly send me some information on how to do this?specifically I would like to add multiple slider interfaces to the web control interface.

Thanks

Todd

2
Technical support / Re:nano 10 clock speed
« on: July 22, 2012, 01:41:49 PM »
Well i wanted to be able to generate around 1-2 Mhz but think  I can work with 50k.

I want to use a series of shift registers to dim Leds individually,using the nano to supply a clock and latch signal, ideally with:
255 levels of dimming
200Hz refresh rate

For 32 leds this would need
255*200*32 = approx 1.6 Mhz

for testing I can use 1 8 bit register at 200Hz with about 30 levels of dimming at 50kHz, so no problem there.

I haven't checked the forums very well but has this been done before, and if so is there code for this floating around? I am really after guidance on a simple iphone interface for this!



3
Technical support / nano 10 clock speed
« on: July 20, 2012, 01:10:45 PM »
Hi there,
can someone please tell the maximum clock speed that can be generated by the nano 10? I can"t find this information anywhere - I'd like to think that the name refers to 10ns and therefore 100 Mhz!

thanks in advance

4
Technical support / Re:nano-10 internet access
« on: November 22, 2011, 08:40:02 AM »
Thanks, I have forwarded this port to my nano IP address and tested this to be working (this was tested using a port checking exe installed on my laptop on the same network, it said the port was open but that it was not able to ping the router tho it knew my external IP).
On trying to access this port using the external IP address (as per the format XX.XXX.XX.XXX:9080) from my phone it was unsuccesful.
has anyone else had this issue, and if so any solution?
the public IP address I used was from whatismyip.com

from the image I attached you can see that I have left the DNS and SMTP addresses as default, from the manual it doesn't sound as if this is necessary for this basic test?

5
Technical support / nano-10 internet access
« on: November 21, 2011, 01:32:08 PM »
Hi there, I have got the nano working on a home wireless LAN so far, using a wireless AP (http://www.tp-link.com/en/products/details/?model=TL-WA701ND#fea) in client mode with the nano plugged into it( via RJ45). I currently am able to access the nano with the standard web interface in a browser with 192.168.1.5:9080 both with a laptop and my phone. The intranet IP is 192.128.1.1

I now want to try and access the nano over the web. I have the Internet IP. How do I go about this? I plan on using my phone to test it. I have included a screenshot of the nano configuration, and I have forwarded port 9080 of the modem for 192.168.1.5 - can someone tell me if this is the correct thing to do? Am I far off getting this to work??!

Thanks in Advance

Todd

Pages: [1]