Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - asitsaha

Pages: [1]
1
Technical support / NANO-10
« on: June 26, 2017, 06:13:39 AM »
I have forgotten the IP address set in nano-10 PLC.  How to do  a factory reset of the PLC so that the IP address is set to default 192.168.1.5 ?  OR  How to find the current IP address set in the PLC
 

2
Technical support / Re:Totalizer for Analog channel Nano-10
« on: May 16, 2014, 12:49:13 AM »
I want to totalize an analog channel value. Let us assume , we have have a gas flow rate signal  (m3/min) connected in a analog channel. We want to inetgrate that flow rate and find the actual gas consumed.  

Hence we need to add
Total = Total + ADC(1) * Scan time of program

How to I get the scan time of program in milli second ?  


3
Technical support / Totalizer for Analog channel Nano-10
« on: May 14, 2014, 05:23:23 AM »
How to create a totalizer for analg channel for nano-10 PLC?  Is there any integrate function to achieve this ? Also any function to get the exact execution time of one cycle of ladder program

4
Technical support / Analog Channel Nano-10 loading
« on: May 03, 2014, 05:55:50 AM »
Wiring done as per Nano-10 user manual. We need to convert 4-20 ma to voltage. I have used 253.16 ohm resistance. The 4-20 ma channel (ABB PLC analog output) supplying the current is getting loaded. Pl suggest the solution

Pages: [1]