Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - smcmains

Pages: [1]
1
Technical support / Re:HMI interface Automation Direct C-more
« on: October 08, 2010, 02:57:16 PM »
I'm currently using C-More Micro HMI's with a T100MD2424+.  I havent seen any problems yet and we are using them on 12 different machines.  I've seen some issues with the PLC's but nothing that is related to the combination of the HMI and PLC.  I'm using about every function that is available on the HMI.

2
Technical support / Run_time error '53'
« on: September 03, 2010, 07:03:37 AM »
I just tried installing Trilogi software on my new desktop with windows 7, 32 bit version.  When trying to open the software after installation I get a    Run_time error '53'  File not found.  Does anyone know what can be done to use the software on this version of windows.  I have tried to reinstall it numerous times and the result is the same.  I have installed it on my laptop with windows 7 without any problems.

Thanks,
Steve

3
Technical support / Saving values in DM[]
« on: August 19, 2009, 06:40:34 AM »
I'm using a T100MD-2424+ PLC for a gauging application in our facility.  I would like to save part count in a DM[] location (every time a part is ran, the part count goes up).  I only have 1 concern.  In the Programmer's Reference (pageA1-6) it states that "EEPROM has a typical life-span of about 100,000 to 1,000,000 erase-write cycle.  Exceeding this limit will "wear out" the EEPROM and resulting in a read error when the PLC operates".  If I'm storing part count in a DM location will this be a problem.  This gage will run aproximately 30,000 parts per week so it would not take long to reach the 100,000 erase-write cycles.  Do the DM's get saved in the EEPROM and will this be a problem.

Pages: [1]