Show Posts
1
Technical support / Re:Help
« on: February 25, 2005, 02:47:15 AM »
Thank you for the help Albert and support. I did indeed figure out, as support suggested, to insert elements while IGNORING some of the directions. I also sent an email to TRILOGI alerting them of not only the TAB key promblem, but also what I perceived as some minor faulty directions which could cause posible confusion for a greenie like me.
Examples of minor faulty directions are:
Step 4:4 Indicates the inserting of a N.C. contact for Manual in Parallel with the Step contact, but the figure below the direction shows that a N.O. contact was just inserted.
Step 4:5 Directs you to insert a special bit to the LEFT of the Manual contact, but the figure in 4:6 clearly shows it to the RIGHT which doesn?t reflect the initial circuit. However, like the support mentioned, the logic is the same. It just caused me some initial confusion which I had to overcome.
Now that I hurrdled the problems, I'm having fun with the program and so far am impressed.
Thanks again.
Jim Sisco
jsisco11@chartertn.net
Examples of minor faulty directions are:
Step 4:4 Indicates the inserting of a N.C. contact for Manual in Parallel with the Step contact, but the figure below the direction shows that a N.O. contact was just inserted.
Step 4:5 Directs you to insert a special bit to the LEFT of the Manual contact, but the figure in 4:6 clearly shows it to the RIGHT which doesn?t reflect the initial circuit. However, like the support mentioned, the logic is the same. It just caused me some initial confusion which I had to overcome.
Now that I hurrdled the problems, I'm having fun with the program and so far am impressed.
Thanks again.
Jim Sisco
jsisco11@chartertn.net