Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - lightbob

Pages: [1]
1
Technical support / Re:Dish Washer
« on: May 27, 2008, 06:44:52 AM »
we basically need two cycle to be timed one is to heating of  the water and the other one is to do the wash cycle, Mostly hot rince, no soap or chemical dispenser.

the water heating cycle may be alternating depending on the wash cycle. the wash cycle may last one or two minutes, and the wash cycle should be conditional to the door being close.

the warming of the water should be conditional if the water sensor detect water.

2
Technical support / Re:Dish Washer
« on: May 26, 2008, 07:35:20 PM »
very nice thank you, do you think i could use an E10-Relay? since i have only few loads to control?

do you have 24 dc power supply? for this unit?

do we need a special cable if i use the starter kit?


this is getting exciting,

3
Technical support / Re:Dish Washer
« on: May 26, 2008, 05:18:35 PM »
It is a commercial dishwasher, i tough you had power supply module? and basically i need few of those 120 relays for the coils of the contactors.

there is a water level sensor and a door magnetic switch the have to be conditional elements before turning the contactor on ( for the motor and for the heating element)

a start button and auto off

4
Technical support / Dish Washer
« on: May 25, 2008, 01:53:09 PM »
I'm a toronto maintenance man in a commercial building,

 i have an old Hobart Dishwasher, the controller has been seriously damage and i cannot find part for it,  

there is a motor contactor, another contactor for the heating element, a water sensor,  and a water valve solenoid to control the water input and a magnetic door switch for security, and power on/off switch (this is also is time control cycle)

i want to replace this junk with new technology so that i can learn and play and experiment with your company controller.

the voltage is mostly 120 volt for all the sensors and coiled off the magnetic contactor.

what would we need as far as module to convert this from it's current state to the basic parts to handle this dishwasher?

thank you, lightbob

Pages: [1]