Show Posts
1
Technical support / HSC help
« on: May 24, 2008, 12:34:47 AM »
HI i am looking at using the +888 instead of omron plcs.
i need encoder inputs to turn outputs on and off also to send receive data - rs232.
i seem to be having a problem with resetting the encoder input all i need is it to count 0-100.
then reset with the omron plcs i used to reset with z phase from encoder and have tried to reset with the Custfn.
is there a better way to do this.
i was using a 360 ppr and i would of asssumed that would of been okay but will changeit to 100 if i need to.
HELP.
Regards
Leon
i need encoder inputs to turn outputs on and off also to send receive data - rs232.
i seem to be having a problem with resetting the encoder input all i need is it to count 0-100.
then reset with the omron plcs i used to reset with z phase from encoder and have tried to reset with the Custfn.
is there a better way to do this.
i was using a 360 ppr and i would of asssumed that would of been okay but will changeit to 100 if i need to.
HELP.
Regards
Leon