1
Technical support / Re: NETCMD$ ?Read or Write error
« on: November 04, 2002, 08:55:09 AM »
I was going to use status, but have not found any information on status command in manual.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Technical support / NETCMD$ ?Read or Write error
« on: November 04, 2002, 02:40:54 AM »
How do I detect a network read or write error. I need to turn off outputs if this happens.
This is the code running.
Z$ = NETCMD$ (3,"@02RVS0101")
IF LEN(Z$) = 0 RETURN : ENDIF
RELAY[3] = HEXVAL(MID$ (Z$,7,4)
This is the code running.
Z$ = NETCMD$ (3,"@02RVS0101")
IF LEN(Z$) = 0 RETURN : ENDIF
RELAY[3] = HEXVAL(MID$ (Z$,7,4)
3
Technical support / Re: Scada
« on: January 14, 2003, 04:27:03 AM »
What is the configuration of the plc? What plc programming is needed?
4
Technical support / Scada
« on: January 13, 2003, 04:25:08 AM »
Using NI Lookout, how are you setting your drivers up?
I want to use com 1 for scada. I only need to pull status form one plc no control is needed.
I want to use com 1 for scada. I only need to pull status form one plc no control is needed.
5
Technical support / PASSWORD
« on: August 15, 2003, 03:31:02 AM »
I have lost my admin password for an installed project. Is there any way short of reinstalling software to recover it?
Pages: [1]