1
Technical support / write EEProm using serial comm.
« on: May 31, 2005, 12:02:41 PM »Using host link command "WXI000101FF*" should set the first address to Hex FF. but returns ER*
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
Using host link command "WXI000101FF*" should set the first address to Hex FF. but returns ER*
2
Technical support / input$
« on: March 25, 2005, 09:07:08 AM »
I am having a lot of difficulty receiving serial data
from a barcode scanner
using the input$(1) function.
After a bad code has been detected by the laser
the plc immediately looks for the data makeing up the
incorrect barcode. Instead of the offending barcde, I usually get previous data or half the data.
If I continue to trigger the laser, eventually the T100MD
will capture the correct data. I know that the laser is transmitting correctly because i can test its output on a terminal.
Any help would be appreciated.
from a barcode scanner
using the input$(1) function.
After a bad code has been detected by the laser
the plc immediately looks for the data makeing up the
incorrect barcode. Instead of the offending barcde, I usually get previous data or half the data.
If I continue to trigger the laser, eventually the T100MD
will capture the correct data. I know that the laser is transmitting correctly because i can test its output on a terminal.
Any help would be appreciated.
3
Technical support / ttl input
« on: August 03, 2004, 04:47:37 PM »Can the M series accept ttl level inputs?
What is max current required by input?
4
Technical support / E series plc
« on: March 23, 2004, 04:00:23 PM »
Can you use basic functions with E-10 like the M series?
5
Technical support / MD-HMI LCD problems
« on: January 10, 2004, 06:04:39 AM »
I have a T100MD888+ and the MD-HMI. The LCD will
go blank randomly. It can only be reset by cycling the power. I have seen other messages with the same problem. I tried all the suggested fixes, Shorter cables,
shielding etc. without much result. I read something about a booster board, would that help? I need to make the unit completely reliable if possible.
Thanks
go blank randomly. It can only be reset by cycling the power. I have seen other messages with the same problem. I tried all the suggested fixes, Shorter cables,
shielding etc. without much result. I read something about a booster board, would that help? I need to make the unit completely reliable if possible.
Thanks
6
Technical support / Active Server Page Control
« on: January 25, 2004, 09:03:31 AM »
I was wondering if it would be possible to use the
serial com VB example as an active X control in an Active server page running on IIS. I was hoping to create a web page GUI contol that would talk to a T100MD+ through the server's serial port as in the Java applet examples.
serial com VB example as an active X control in an Active server page running on IIS. I was hoping to create a web page GUI contol that would talk to a T100MD+ through the server's serial port as in the Java applet examples.
Pages: [1]