1
Technical support / Trilogi 6.1 under XP
« on: February 26, 2007, 08:34:21 AM »
We can't seem to get 6.12 to run on our XP machine. Server 3.0 runs fine. We get "Could not find main class. Program will exit." error. Any thoughts?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Technical support / Re:Ladder printing problem
« on: April 22, 2004, 11:20:19 AM »
I can't seem to find where I can update the software. Is there a link?
Thanks,
Lloyd
Thanks,
Lloyd
3
Technical support / Ladder printing problem
« on: April 21, 2004, 10:19:24 AM »
I am having trouble printing the ladder portion of my program. The very right edge of the coil names is always cut off. I have tried to adjust the "width" as well as the printer scaling and have tried several different printers all with no effect. Is there a solution?
Thanks,
Lloyd
Thanks,
Lloyd
4
Technical support / Re:Can't compile function
« on: February 20, 2004, 06:48:55 AM »
Sorry, here is the code:
IF CtrPV[11]=1 THEN
DM[25]=CtrPV[20]
SETBIT RELAY[42]
ENDIF
IF CtrPV[11]=0 THEN
CLRBIT RELAY[41]
X$=""
W$=""
ENDIF
IF CtrPV[11]=2 THEN
FOR C=0 TO 50
CLRBIT DM[C+100]
CLRBIT DM[C+200]
CLRBIT DM[C+300]
CLRBIT DM[C+400]
CLRBIT DM[C+500]
CLRBIT DM[C+600]
CLRBIT DM[C+700]
NEXT
ENDIF
IF CtrPV[11]=1 THEN
DM[25]=CtrPV[20]
SETBIT RELAY[42]
ENDIF
IF CtrPV[11]=0 THEN
CLRBIT RELAY[41]
X$=""
W$=""
ENDIF
IF CtrPV[11]=2 THEN
FOR C=0 TO 50
CLRBIT DM[C+100]
CLRBIT DM[C+200]
CLRBIT DM[C+300]
CLRBIT DM[C+400]
CLRBIT DM[C+500]
CLRBIT DM[C+600]
CLRBIT DM[C+700]
NEXT
ENDIF
5
Technical support / Can't compile function
« on: February 20, 2004, 06:48:13 AM »
I am having a strange problem with this custom function. If I re-arrange the order of the IF-THEN-ELSE statements, it fails at different locations with "Syntax error" Is there a limit to the size of the file/ladder diagram/custom function that I am running into?
Thanks,
Lloyd
Is there a limit to the size of the file/ladder diagram/custom function that I am running into?Thanks,
Lloyd
6
Technical support / Re:Reading counter present value
« on: February 17, 2004, 06:21:41 AM »
Thanks support, you hit the nail on the head!
7
Technical support / Reading counter present value
« on: February 13, 2004, 01:09:55 PM »
I can't figure out why this statement in a custom function does not work...
IF CtrPV[9]=1 THEN
SETBIT OUTPUT[1],0
ENDIF
Thanks,
Lloyd
IF CtrPV[9]=1 THEN
SETBIT OUTPUT[1],0
ENDIF
Thanks,
Lloyd
Pages: [1]