Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gibus

Pages: [1]
1
Technical support / Re:Display String
« on: July 22, 2004, 07:07:22 AM »
 Hi Support

I"ve got it worked now, many thanks for your help.
I also would like to know how many new TBasic commands you have so far, because in my TBasic manual, it does not have the command you mention.

gibus

2
Technical support / Display String
« on: July 17, 2004, 03:20:46 AM »
Hi

I've been playing with the T100MD+ for sometime now and really enjoy using it. However, there are some problems I can not solve and would like to ask few questions:

1. I use VB to send host commands for writing integer and string variable to PLC,  now I want to display these setting on the LCD using TBasic. For example I use one input as increase button and another input as decrease button. By pressing increase, it will show numbers from 1 to 26 or from 26 to 1 depend on which button is pressed. At the same time A$ to Z$ should display the string content. I can use "RV$" command to show the string but I can not do it in TBasic. Do you have any similar command in TBasic?

2. Provide that I don't care about real time clock, can I connect battery to SRAM in order to save the content when the PLC is turn off?

3. Is it possible to upgrade the firmware to new version in order to use new commands?
Mine is version r44.

Gibus

Pages: [1]