Show Posts
1
General Discussions / High Spped Counter
« on: February 27, 2007, 02:47:12 AM »
Hi Dear,
I am using GE Fanuc PLC for the Viscosity Program, in this program i m using Output-3 as a counter but there is some problem in this program. When i run the program the Puls Complete bit is ON befor that bit get the enable bit.
Please help me to understand the logic of the High Speed Counter
Thanks
I am using GE Fanuc PLC for the Viscosity Program, in this program i m using Output-3 as a counter but there is some problem in this program. When i run the program the Puls Complete bit is ON befor that bit get the enable bit.
Please help me to understand the logic of the High Speed Counter
Thanks