1
Technical support / Re: getting a program off of a PLC
« on: May 10, 2002, 10:29:39 AM »
Thanks for the quick response, I will have to be more careful about backups in the future.
Will
Will
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Technical support / getting a program off of a PLC
« on: May 10, 2002, 05:30:08 AM »
Hi, the new forum looks good.
I recently had my PC at work formatted, losing the programs I had written for my T100MD888 PLC. The PLC still works fine and after reinstalling the TriLogi software I can communicate PC to PLC. I tested this by setting the real time clock. When I try to open the program stored on the PLC I get an error message.
I have tried this two different ways, one by opening the matching source file: I get an error message that says that the file is not found or not a valid TriLogi file.
Then I tried opening the file from the TL server, when I do this I find only an empty directory.
Is there another way to try to download the program from the PLC to the computer? Am I making some other obvious mistake? I have hard copies of my programs but I would rather not try to redo the programs on my computer.
Thanks for any advice,
Will
I recently had my PC at work formatted, losing the programs I had written for my T100MD888 PLC. The PLC still works fine and after reinstalling the TriLogi software I can communicate PC to PLC. I tested this by setting the real time clock. When I try to open the program stored on the PLC I get an error message.
I have tried this two different ways, one by opening the matching source file: I get an error message that says that the file is not found or not a valid TriLogi file.
Then I tried opening the file from the TL server, when I do this I find only an empty directory.
Is there another way to try to download the program from the PLC to the computer? Am I making some other obvious mistake? I have hard copies of my programs but I would rather not try to redo the programs on my computer.
Thanks for any advice,
Will
Pages: [1]