Show Posts
1
Technical support / Direction of encoder
« on: May 10, 2002, 07:00:01 AM »
I am using an encoder on the T1000MD-OV1. The encoder has 360 counts per revolution and it works great on inputs 3&4 for HSC1.
I set the PV of HSC1 to zero when the counter = 360. This works fine in the forward direction but I can't figure out how to set the PV to zero in the reverse direction.
I can't guarantee motor direction because in this application sometimes the user will turn on the motor to get the flywheel spinning and then shut if off so that they can jog the machine slowly. I also have counter balance which will sometimes pull the machine in reverse for a split second in the time between the brake releasing and the clutch engaging even with the motor in the forward direction.
Is there any way to define two high speed counters using the same inputs? I know I could jumper 3&4 to 5&6 and define HSC2 to set the PV's of both counters to 359 when it goes negative but I was hoping for another solution because I may be short on inputs.
I set the PV of HSC1 to zero when the counter = 360. This works fine in the forward direction but I can't figure out how to set the PV to zero in the reverse direction.
I can't guarantee motor direction because in this application sometimes the user will turn on the motor to get the flywheel spinning and then shut if off so that they can jog the machine slowly. I also have counter balance which will sometimes pull the machine in reverse for a split second in the time between the brake releasing and the clutch engaging even with the motor in the forward direction.
Is there any way to define two high speed counters using the same inputs? I know I could jumper 3&4 to 5&6 and define HSC2 to set the PV's of both counters to 359 when it goes negative but I was hoping for another solution because I may be short on inputs.