Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - prginocx

Pages: [1]
1
Technical support / Re:Using output twice
« on: September 14, 2006, 01:42:24 PM »
So really what you are saying is I have a Fundamental Mis-Understanding of ladder logic ?   That is entirely possible, likely even...

No wonder I couldn't figure it out.   I will do your solution and see how it works.   Thank you very much.

2
Technical support / Re:Using output twice
« on: September 14, 2006, 10:51:20 AM »
I'm not quite sure I understand.    Are you saying I can't have a rung with RLY1 turning on Output 1 via the .5mS special relay blinking..

And then another rung with RLY2 turning on Output 1 solid ON.

So there is NO way to utilize the light blinking for one purpose, then solid ON for another purpose ?

3
Technical support / Using output twice
« on: September 13, 2006, 01:21:38 PM »
In my ladder rungs I want to latch two different relays at two different
times, but they will activate the same output a different way.   This is to generate two fault messages.   One blinking light, one solid light ON.

Program won't allow me to do this.   In fact I can't operate them in the manual mode, either "monitoring mode".

Pages: [1]