16
Technical support / Re:Input stays on
« on: March 09, 2007, 01:02:19 PM »
Ok so whats the best way to fix it ? I tried reloading software but on line monitoring shows input still on. Everything else works fine.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: 1 [2]
17
Technical support / Input stays on
« on: March 08, 2007, 11:59:36 PM »
Hi have a problem with a T100MD1616, for some reason input 7 seems to have latched on and stays on even with the connector block removed. Any ideas ?
18
Technical support / Re:Oops
« on: May 03, 2006, 02:35:05 AM »
Thanks for help , Eprom found faulty , replaced with one from another damaged board, all ok now owner informed of the error of his ways 
19
Technical support / Oops
« on: May 01, 2006, 02:35:25 AM »
Recently installed T100md888 in mercedes truck to interface a radio remote control with the electronic engine management system, was working fine until the owner disconnected to batteries with the plc still powered up, suspect some arcing took place as now plc doesn't work. Now for some reason when I try communicate with the plc it ask's for a password and gives the id as " BF " . As a password was not origionaly required, any ideas on how to by pass the password thing or do you think a new 888 is needed ?
Pages: 1 [2]