1
Technical support / Using output twice
« on: September 13, 2006, 01:21:38 PM »
In my ladder rungs I want to latch two different relays at two different
times, but they will activate the same output a different way. This is to generate two fault messages. One blinking light, one solid light ON.
Program won't allow me to do this. In fact I can't operate them in the manual mode, either "monitoring mode".
times, but they will activate the same output a different way. This is to generate two fault messages. One blinking light, one solid light ON.
Program won't allow me to do this. In fact I can't operate them in the manual mode, either "monitoring mode".