Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ICIII

Pages: [1]
1
Technical support / Re: Multipoint host-link trouble
« on: September 10, 2003, 11:43:59 AM »
Thank you for your quick answer. I have made the test and everything worked correctly.
A last question:
 I'll  to send the command of a swich via a serial port   to act on the LADER
Is a good practice to send a WIxxxx host-link command , or is  better to make it to a DM [] with a WVDxxxxxxxx  host-link command and then to use a CusFn?

2
Technical support / Multipoint host-link trouble
« on: September 09, 2003, 01:12:35 PM »
I am testing to send to the T 100 M+ PLC commands via multipoint host-link with the Trilogi Server and seeing the result with the simulator of the Trilogi 5.2 using the two com port. When I send a command to write  a DM(), this is visualized immediately in the simulator, on the other hand, if I send a command to write a INPUT () channel cannot be able to see the change in the simulator even to capture the message through  the LCD display and to see that it is correct.
The sent commands are:
 
To Write a DM(1) the letter ?A?
 @ 02WVD0001004103 * +CR
 the answer is @02WVD07 *
 
To write an  INPUT(9) the value 66H
@02WI096655 *   +CR
  the answer is @02WI5C *
 
Please, tell me where I make the mistake?
 
Thank you in advance
  
Roberto G?mez
 
 Sorry for my English

Pages: [1]