Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - brett

Pages: [1]
1
Technical support / Re:ADC voltage
« on: November 21, 2006, 10:06:34 PM »
Tried it and its working fine!
Thanks for the help... Such a silly thing to overlook.  :P

2
Technical support / ADC voltage
« on: November 21, 2006, 06:41:46 AM »
I recently bought a T100MD-888+ PLC,

I put a pot across the Analogue supply and read the ADC(1) input to an LCD, between 1.2 and 5 Volts I get 1000 to 4092, anywhere below 1.2v The values roll over to 9960 and then drop off drastically before rolling over once more at 0v, is this normal? And if so, is there any way to set the range of the ADC's for 0 to 5 v input?

Thanks

Pages: [1]