1
Technical support / Re:National instruments Lookout V6
« on: October 27, 2006, 04:31:59 AM »
Thanks so much for your help. Now I understand. It works fine now
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Technical support / Re:National instruments Lookout V6
« on: October 26, 2006, 10:27:39 AM »
Thanks for the response.
If I understand you correctly all I need to do is send date out at a specific modbus address i.e 40001. Is that correct ?
Would you have an example that I could try?
If I understand you correctly all I need to do is send date out at a specific modbus address i.e 40001. Is that correct ?
Would you have an example that I could try?
3
Technical support / National instruments Lookout V6
« on: October 26, 2006, 05:40:22 AM »
I?m attempting to get communication from the M series PLC to lookout V6 via com port 1. I?m using this code WRITEMODBUS 1, 1, 1000, 1234
The response I get back from lookout is ?communication garbled from modbus secondary? Response to short.
Can you help? Any sample code will help.
The response I get back from lookout is ?communication garbled from modbus secondary? Response to short.
Can you help? Any sample code will help.
Pages: [1]