Internet PLC Forum

General => General Discussions => Topic started by: Meghana Nair on February 27, 2007, 02:47:12 AM

Title: High Spped Counter
Post by: Meghana Nair on February 27, 2007, 02:47:12 AM

Hi Dear,

I am using GE Fanuc PLC for the Viscosity Program, in this program i m using Output-3 as a counter but there is some problem in this program. When i run the program the Puls Complete bit is ON befor that bit get the enable bit.


Please help me to understand the logic of the High Speed Counter

Thanks