Internet PLC Forum

General => Technical support => Topic started by: artkraft on October 10, 2005, 10:10:44 PM

Title: keyPad-MD.pc5
Post by: artkraft on October 10, 2005, 10:10:44 PM

Can this program in the samples file be modified to work with the MD-HMI
on a T100MD+2424.

Title: Re:keyPad-MD.pc5
Post by: support on October 10, 2005, 10:26:34 PM

Sure you can. However, there are already samples programs for using the T100MD224+ with MD-HMI. They are all in the subfolder:

 C:\TRiLOGI\TL5\usr\samples\HMI

These programs are easier to modify to adapt to your needs.

Title: Re:keyPad-MD.pc5
Post by: artkraft on October 10, 2005, 10:34:49 PM

i've looked at those. I want to change a value of x with direct entry of key pad. I can get the program to work with keys 0-2. they are on channel 2. higher keys move into channel 3. that is where I am stuck.

Title: Re:keyPad-MD.pc5
Post by: support on October 11, 2005, 12:20:38 AM

Look at the program "HMI25to40.PC5". It is specifically written to handle the word boundaries issue arising from using MD-HMI with T100MD2424+.