Internet PLC Forum

General => Technical support => Topic started by: torobeldor on November 10, 2009, 07:21:22 PM

Title: Uses LED?s
Post by: torobeldor on November 10, 2009, 07:21:22 PM

Hi, I?am form argentina. First, sorry for my stuped question, but can?t  find to use LEDs in the table of variables. I study "contrul at de university and its very difucult to me use your english manuls.

I hope your answer

Title: Re:Uses LED?s
Post by: support on November 11, 2009, 10:47:23 PM

What do you mean by LEDs in table of variables? In the simulator there is a row of squares that turns RED when the corresponding I/O is activated and we call it LEDs - just like the LEDs in the real PLCs. If you click on an input its "LED" will light up.

Title: Re:Uses LED?s
Post by: torobeldor on November 12, 2009, 05:20:52 AM

Ok, then the LED?s in table of variables has not funtion??

Thanks

Title: Re:Uses LED?s
Post by: support on November 12, 2009, 03:54:42 PM

You are referring to those LEDs that are supposed to be activated by SETLED command. These are supported in simulator but not supported in any of our PLC. It was meant for displaying some 7-segment LED display. You can use the SETLED command to play with it in the simulator but there is no real applicaton since none of the current PLC support it.

Title: Re:Uses LED?s
Post by: torobeldor on November 12, 2009, 04:54:05 PM

Ok thanks you. Yes I used it in educational simulator for any automation of work of the university.

Thanks you again