Internet PLC Forum

General => Technical support => Topic started by: LogicRetrofitters on May 20, 2007, 06:08:54 PM

Title: Beginner needs help
Post by: LogicRetrofitters on May 20, 2007, 06:08:54 PM

I am designing my first Tri and can't quite figure out which inputs are digital and which are analog. Same for outputs. The T100MD+ User's Manual doesn't really help me with where to hook up my inputs on my 888+. Thanks for your help.

Title: Re:Beginner needs help
Post by: support on May 20, 2007, 07:21:08 PM

You should refer to the T100MD888+ Installation guide (8 page white color booklet) which shows you where the digital inputs, outputs and analog I/Os are.

Title: Re:Beginner needs help
Post by: LogicRetrofitters on May 22, 2007, 07:55:56 PM

AHA! The plot thickens. I got two green books. No white one for the 888+ like the one with the E-10 I ordered at the same time. I will look around to see if that can be downloaded.

Thanks mucho!!!
Ben

Title: Re:Beginner needs help
Post by: support on May 22, 2007, 08:28:20 PM

The white installation guide is normally enclosed inside the PLC box (not in the starter kit pack). We apologize if it is not in the box but the PDF file can be downloaded from:

  http://www.tri-plc.com/t100md888.htm

Just click on the "installation guide" link and it will be downloaded.
Did you get a blue color "T100MD+ User Manual"? This one can also be downloaded from the above link.

Title: Re:Beginner needs help
Post by: LogicRetrofitters on May 30, 2007, 04:56:33 PM

Got it! Thanks mucho!

Ben