1
Technical support / (Warning: No Response from PLC !)
« on: June 20, 2007, 10:59:01 AM »
Hi there,
Brand new to this. I have a T100MD-888+ and get the message
(Warning: No Response from PLC !) when I try to send the IR* string in the Serial Commd Setup screen. Ive set the PC port to match the Baud rate and Comm1, parity,stop etc but get no other message. Get an error if I try to Detect PLCID. I have a Switch mode PSU connected at 24v (ATX unit for a PC). I dont think I have any other software which is using the RS232 port.
Tried just transferring a sample program also doesn't connect
Any help gratefully recieved. Wakko
Brand new to this. I have a T100MD-888+ and get the message
(Warning: No Response from PLC !) when I try to send the IR* string in the Serial Commd Setup screen. Ive set the PC port to match the Baud rate and Comm1, parity,stop etc but get no other message. Get an error if I try to Detect PLCID. I have a Switch mode PSU connected at 24v (ATX unit for a PC). I dont think I have any other software which is using the RS232 port.
Tried just transferring a sample program also doesn't connect
Any help gratefully recieved. Wakko