Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - MHN

Pages: [1]
1
Technical support / Form of Analog Input
« on: May 05, 2009, 05:50:12 AM »
T100MD888+

I have a windmill giving AC voltage out from 0 to 130 Volts

I want an input reflecting RPM or Voltage. Do I need to convert to DC if I use 0-20 mA or 0-10 V.

What load in voltage can the PLC take on the Pulse measurement input? Could i use some kind of diode that will work on low and high Voltage and still not be burned or burn the PLC

Programming will be controlling load on the windmill depending on the windspeed.
 ???http://

Pages: [1]