Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - lyndon

Pages: [1]
1
Technical support / Ver. 5.1
« on: April 01, 2003, 12:47:18 PM »
I am just starting to learn your PLC simulator but I see the beauty of the ver. 5.1, how do I download it?  I have the Dos version only.  I see the power of the 5.1 for the networking purposes.  Please let me know.  Do you have a distributor in the Philippines of your PLCs?  I  like to be very good with your PLC and promote here in my country ::).

Regards,

2
Technical support / E10-npn RS232 Communication
« on: April 07, 2003, 08:05:23 PM »
Can we make the E-10 plc as a slave to communication device such as modem and wireless phone?  

Does the internal output can be used to send ACSII commands to the host? What set of ACS ii host link commands does it contains?

Regards,

Lyndon

3
Technical support / ACS II Command of Wireless Modem
« on: April 14, 2003, 05:27:52 PM »
One of the commands to be send out by the TD100M+ PLC to the wireless modem via comm #1 is:

AT+CMGS=<index>,<tel.no.><CR><LF>data<Crtl+Z>

Where <Ctrl+Z> means end of data message

Is this the right interpretation at the PLC Print Command?

Print #1 "AT+CMGS=1, 1234567"
Print #1 "Hello World ^Z"

As the print command adds CR code, what about the LF (line feed) how do we handle this +CHR$(&H0B)

Also I found that Crtl+Z in Dos Mode is shown as ^Z. Does the ACS II Code intrepret Crtl a ^?

Please let me know.


4
Technical support / PulseFrequency & Input #3
« on: April 21, 2003, 03:03:47 PM »
Would it be possible to use the Special I/O input #3 as PulseFrequency Ch #1 to calculate speed and at the same time use its NPN optic-sensor to trigger a counter that would calculate the distance travelled eventually?

Why I can't simulate the Pulsefrequency similar to an ADC input ch even when I excusively used the Input #3 as a Pulsefrequency channel?




5
Technical support / PulseFrequency and Counter
« on: April 21, 2003, 04:07:47 PM »
On the same special input #3, can use the npn optic-sensor as a pulsefrequency (1) and trigger a counter in the plc ladder?  The counter would calculate the distance travelled and pulsefrequency to calculate the speed.

How can I simulate the pulsefrequency function similar to ADC?

Pages: [1]