Internet PLC Forum

General => Technical support => Topic started by: dror on November 27, 2010, 03:08:20 AM

Title: Simple\Lite SCADA application
Post by: dror on November 27, 2010, 03:08:20 AM

Is anyone ever needed a Simple\Lite SCADA\HMI  like SW application to control and monitor a few Inputs\Outputs\Relays\Values etc of any of the Trilogi PLCs?
 
Is anyone ever found\used such a SW application?

Any lead will be highly appreciated.

Dror

Title: Re:Simple\Lite SCADA application
Post by: support on November 27, 2010, 06:39:36 AM

You can visit the following link:

http://infiniteautomation.com/uploads/Tri-PLC-Setup.swf

This user has developed a simple panel to monitor a nano-10 PLC via the TCP/IP.

There are also other GUI/SCADA that you can check out from:

http://www.tri-plc.com/modbus.htm

I think DAQfactory and Eclipse provides low cost graphic SCADA type software that can communicate with our PLC. Please contact the vendor for more information.

Title: Re:Simple\Lite SCADA application
Post by: william on November 27, 2010, 12:23:22 PM

Take a look at http://www.sweetwilliamsl.com/iweb/smhome where there is a simple and inexpensive scada system for the iphone/ipad. It runs on my itouch and communicates nicely over modbus TCP to the F series(and I assume nano) PLC's. Perfect for a home automation project.

Title: Re:Simple\Lite SCADA application
Post by: dror on November 27, 2010, 12:41:11 PM

Hi William,

10X, It looks great, unfortunately it works on Iphone\Ipad only. I wish I could  find a similar application for PC.