Internet PLC Forum

I am testing to send to the T 100 M+ PLC commands via multipoint host-link with the Trilogi Server and seeing the result with the simulator of the Trilogi 5.2 using the two com port. When I send a command to write  a DM(), this is visualized immediately in the simulator, on the other hand, if I send a command to write a INPUT () channel cannot be able to see the change in the simulator even to capture the message through  the LCD display and to see that it is correct.
The sent commands are:
 
To Write a DM(1) the letter ?A?
 @ 02WVD0001004103 * +CR
 the answer is @02WVD07 *
 
To write an  INPUT(9) the value 66H
@02WI096655 *   +CR
  the answer is @02WI5C *
 
Please, tell me where I make the mistake?
 
Thank you in advance
  
Roberto G?mez
 
 Sorry for my English