Internet PLC Forum

General => Technical support => Topic started by: BC SYSTEMS on April 15, 2011, 02:28:33 AM

Title: Nano Relays
Post by: BC SYSTEMS on April 15, 2011, 02:28:33 AM

Hi Guys,

I'm using the outputs on a nano to indicate if the communication on the serial and Ethernet port is working OK.  I need all four outputs which is fine for  outputs 1 & 2 but 3 & 4 are also connected to relays.

When the comm's is running the relays are on and off every second which is probably not doing them any good but perhaps more important, they are driving me mad!

Would there be any adverse situations if I just de-solder the relays.

Cheers

Title: Re:Nano Relays
Post by: support on April 15, 2011, 10:29:04 AM

You can de-solder the 2-relays and they will be taken out of service. But you will need to short the solder pads on the solder side of the Nano-10 to re-route the MOSFET driver to the screw terminal block.

Title: Re:Nano Relays
Post by: BC SYSTEMS on April 15, 2011, 11:32:12 AM

Ok thanks.  

Cheers