Internet PLC Forum
General => Technical support => Topic started by: GuillaumeB on October 27, 2011, 04:24:27 AM
-
Hello,
To begin, I apologize in advance for my English language.
I need help to programming a stepper motor with controler nano10 then driver M880A.
I control this motor with 2 command buttons (backward / forward) By means of stepspeed and stepmove program.
I would like to add analog input control for modify motor speed .
When i change the pps to DM- in stepspeed (DM
- is my speed value in pps), an error message occurs:
(Error:Illegal Pulse Rate for STEPMOVE!
Program has been Halted!)
i' m a recent user of plc nano-10 and i-Trilogi i would like to find someone with solutions to help me
Thanks.
-
Is it because your DM is currently at 0? stepper pulse rate cannot be zero and it will therefore report an error. I tried the following and it compiled and simulated successfully:
DM[10] = 1000
DM[11] = 10
STEPSPEED 1, DM[10], DM[11]
STEPMOVE 1, 2000,5
P.S. Your English is very good! No problem understanding your question at all. :)
-
Thank you for your answer!
That do not resolve the probleme directly but i found it with your help.
The probleme is: i don't compiled any program. >.>
one more time thank you master of plc :)
i going sleeping less silly tonight.