Internet PLC Forum
General => Technical support => Topic started by: philipjoseph on February 10, 2003, 05:33:04 AM
-
Do you know where can I find information about some special caracters that I can use with the LCD420?
I don't remember where do I find a table with some caracteres like CHR$(12) No cursor at the screen.
Philip
-
You can download the full manual for the LCD from our webpage:
http://www.tri-plc.com/lcd.htm
or:
http://198.22.62.9/pdfs/Dmcman_full.pdf
Those special commands and characters table are in the manual.
-
I found them.
They are at the T100MD+ manuel, section 4 (LCD module)
-
I looked in Chapter 4 (Command/Response Format) of the T100MD+ User's Manual and I did not find any reference to LCD Commands. My manual is Copyright 2001. Do I have an old copy without these commands?
-
Optrex has moved itself website IP address. So you should download the full manual from:
http://www.optrex.com/pdfs/Dmcman_full.pdf